Maintaining the TM_U950                                                                                Page 8

Click Image to Enlarge / Reset

The in-store maintenance procedure.
To extend the operating life of the TM-U950 a simple procedure is required.

Remove power - be sure to shut down the system.
Turning off and on the power to the console or printer individually can cause hardware failure or software corruption.



1.  Open the lid
2.  Remove the Ribbon.
3.  Remove the two screws holding the metal ribbon carrier.
4.  With compressed air ( can of keyboard cleaner ) blow out all the paper dust in and around the two sensors.   The home sensor and the position sensors.
5 . Place Three-in-One oil (not too much) on both sides of the print head carriage, where the print head rides on the steal bar. You will notice felt oilers. Or place a few drops of the oil on the steal bar and gently slide the print head to the right and then place a few drops on the left side of the steal bar..

Place a few drops of oil on the surface closest to the front of the printer where the print head carriage rides.  



The depot level maintenance procedure

Dubble Click to Reduce --- Page One
_____________________________________

The in-store maintenance procedure.
To extend the operating life of the TM-U950 a simple procedure is required.

Remove power - be sure to shut down the system.
Turning off and on the power to the console or printer individually can cause hardware failure or software corruption.



1.  Open the lid
2.  Remove the Ribbon.
3.  Remove the two screws holding the metal ribbon carrier.
4.  With compressed air ( can of keyboard cleaner ) blow out all the paper dust in and around the two sensors.   The home sensor and the position sensors.
5 . Place Three-in-One oil (not too much) on both sides of the print head carriage, where the print head rides on the steal bar. You will notice felt oilers. Or place a few drops of the oil on the steal bar and gently slide the print head to the right and then place a few drops on the left side of the steal bar..

Place a few drops of oil on the surface closest to the front of the printer where the print head carriage rides.  



The depot level maintenance procedure

xhead2

xsupport2

Dubble Click to Reduce Page Two  
_____________________________________

xsupport2